PnP QFN-32 5×5 0.5
QFN / DFN / LGA · 5.00 × 5.00 · 0.5 pitch · 32 pins
Package drawing
Top view, to scale, drawn by the same engine the app uses. Letters match the datasheet. In the app you can flip to the bottom view, which is how most datasheets draw it.
Numbers to program
| Body D | 5 mm |
|---|---|
| Body E | 5 mm |
| Height (A) | 0.8 – 1 (nom 0.9) mm |
| Pitch e | 0.5 mm |
| Leads / pins / balls | 32 |
| Lead width b | 0.18 – 0.3 (nom 0.24) mm |
| Lead length L | 0.3 – 0.5 (nom 0.4) mm |
| Exposed pad D2 | 3.4 mm |
| Exposed pad E2 | 3.4 mm |
| Tape | 12 mm wide / 8 mm pitch |
Center pad (EP) size is typical only; it varies most between makers.
Typical industry values for this package. Always confirm against the datasheet for the exact part number and suffix you are placing, and check the first board.
What to watch on QFN / DFN / LGA
- Reading a bottom-view drawing as if it were the top view, so pin 1 ends up mirrored
- Typing mils into a millimeter field
- Building a HotRod or flip-chip part as a normal QFN
- Leads so wide for the pitch that they bridge
Read the full guide: QFN, DFN and LGA packages.
Program it on your machine
PnP Toolkit sets its words and setup sheet for your machine. Pick yours for the step-by-step:
Tools that use this part
FeatureQFN decoderType the numbers from the package drawing exactly as printed, like “0.18 0.25 0.30”. The decoder picks the nominal,…FeatureParts libraryA built-in library of 179 packages and real part numbers, each with body and lead sizes, tape, MSL level and, for 104…FeatureRotation helperWorks out the turn angle when pin 1 on the tape is not where the CAD data expects it, and adds it to the placement…
More QFN / DFN / LGA
- DFN-8 3×3 0.65
- DFN-10 3×3 0.5
- QFN-16 3×3 0.5
- QFN-20 4×4 0.5
- QFN-24 4×4 0.5
- QFN-32 4×4 0.4
- QFN-28 5×5 0.5
- QFN-40 6×6 0.5
- All 12 →
Try PnP Toolkit free for 30 days
No credit card. Works on any phone or line PC. After the trial it’s $49/month per machine.